MICHELIN 12294A

Michelin 12294A Digital Programmable Tire Pressure Gauge

ഉപയോക്തൃ മാനുവൽ

ആമുഖം

Thank you for choosing the Michelin 12294A Digital Programmable Tire Pressure Gauge. This device is designed for accurate and convenient measurement of tire pressure, ensuring optimal vehicle performance and safety. Please read this manual thoroughly before use.

പാക്കേജ് ഉള്ളടക്കം

  • 1 x Michelin 12294A Digital Programmable Tire Pressure Gauge
  • 2 x Lithium-metal batteries (pre-installed or included)
Michelin 12294A Digital Programmable Tire Pressure Gauge

Image: The Michelin 12294A Digital Programmable Tire Pressure Gauge, showing its digital display and control buttons.

സജ്ജമാക്കുക

ബാറ്ററി ഇൻസ്റ്റാളേഷൻ

The device requires 2 Lithium-metal batteries. These are typically included or pre-installed. If replacement is needed:

  1. Locate the battery compartment cover, usually on the back or side of the unit.
  2. കവർ തുറക്കുക.
  3. ശരിയായ പോളാരിറ്റി (+/-) ഉറപ്പാക്കിക്കൊണ്ട് ബാറ്ററികൾ തിരുകുക.
  4. ബാറ്ററി കമ്പാർട്ട്മെൻ്റ് കവർ സുരക്ഷിതമായി അടയ്ക്കുക.

പവർ ചെയ്യുന്നത് ഓൺ/ഓഫ്

  • പവർ ഓണാക്കാൻ, അമർത്തുക പവർ ബട്ടൺ (often marked with a circle and vertical line symbol).
  • The backlit LCD display will illuminate.
  • ബാറ്ററി ലൈഫ് ലാഭിക്കുന്നതിനായി, ഒരു നിശ്ചിത കാലയളവ് പ്രവർത്തനരഹിതമായ ശേഷം ഉപകരണം യാന്ത്രികമായി ഓഫാകും.

പ്രവർത്തന നിർദ്ദേശങ്ങൾ

ടയർ മർദ്ദം അളക്കുന്നു

  1. Ensure the tire is cold for the most accurate reading.
  2. ടയറിൽ നിന്ന് വാൽവ് ക്യാപ്പ് നീക്കം ചെയ്യുക.
  3. Press the nozzle of the gauge firmly onto the tire valve stem. A good seal is crucial for an accurate reading.
  4. The digital display will show the tire pressure.
  5. Remove the gauge from the valve stem. The reading will hold on the display for a short period.
  6. വാൽവ് തൊപ്പി മാറ്റിസ്ഥാപിക്കുക.
Michelin 12294A Tire Pressure Gauge in use on a car tire

Image: The Michelin 12294A gauge being used to measure pressure on a car tire valve.

അളക്കൽ യൂണിറ്റുകൾ മാറ്റുന്നു

The gauge supports measurements in PSI, KPA, BAR, and kg/cm². To cycle through units, press the യൂണിറ്റ് ബട്ടൺ (often the same as the power button or a dedicated button). The current unit will be displayed on the screen.

Programming Tire Pressures

This gauge can be programmed with target front and rear tire pressures for up to two vehicles. Refer to your vehicle's owner's manual or the sticker on the driver's side door jamb for recommended tire pressures.

  1. With the gauge powered on, press and hold the പ്രോഗ്രാം ബട്ടൺ (often an arrow button or a dedicated 'SET' button) until the programming mode is activated.
  2. ഉപയോഗിക്കുക മുകളിലേക്ക്/താഴേക്ക് അമ്പടയാള ബട്ടണുകൾ to adjust the target pressure for the front tires of Vehicle 1.
  3. അമർത്തുക പ്രോഗ്രാം ബട്ടൺ again to switch to the rear tires of Vehicle 1, then adjust.
  4. Repeat the process for Vehicle 2 if desired.
  5. The gauge will save the settings automatically after a few seconds of inactivity or by pressing the Program button to exit.
Close-up of Michelin 12294A display showing current and target PSI

ചിത്രം: ഒരു ക്ലോസ്-അപ്പ് view of the gauge's digital display, showing current pressure and programmable target pressure settings.

Using the Integrated Flashlight

The gauge features an integrated flashlight to assist in locating the tire valve in low-light conditions. To activate the flashlight, press the ഫ്ലാഷ്ലൈറ്റ് ബട്ടൺ (refer to device markings, often combined with another function or a dedicated button).

Using the Bleed Valve

If a tire is over-inflated, the built-in bleed valve allows for controlled release of air. While the gauge is attached to the valve stem and displaying pressure, gently press the Bleed Valve button (if present, often a small button near the nozzle) to release air until the desired pressure is reached.

മെയിൻ്റനൻസ്

  • വൃത്തിയാക്കൽ: Wipe the gauge with a soft, dry cloth. Do not use abrasive cleaners or immerse the device in water.
  • സംഭരണം: Store the gauge in a cool, dry place, away from direct sunlight and extreme temperatures.
  • ബാറ്ററി മാറ്റിസ്ഥാപിക്കൽ: If the display becomes dim or the device does not power on, replace the batteries. Dispose of old batteries according to local regulations.

ട്രബിൾഷൂട്ടിംഗ്

പ്രശ്നം സാധ്യമായ കാരണം പരിഹാരം
No display/Device does not power on ഡെഡ് അല്ലെങ്കിൽ തെറ്റായി ഇൻസ്റ്റാൾ ചെയ്ത ബാറ്ററികൾ. ബാറ്ററി പോളാരിറ്റി പരിശോധിക്കുക അല്ലെങ്കിൽ ബാറ്ററികൾ മാറ്റിസ്ഥാപിക്കുക.
കൃത്യമല്ലാത്ത വായന Poor seal with valve stem; tire not cold; gauge malfunction. Ensure a firm, airtight seal. Measure when tires are cold. If issues persist, contact support.
Air leaks when measuring Gauge not properly seated on valve stem. Press the gauge firmly and squarely onto the valve stem.

സ്പെസിഫിക്കേഷനുകൾ

ബ്രാൻഡ് മിഷെലിൻ
മോഡൽ നമ്പർ 12294എ
മോഡലിൻ്റെ പേര് പ്രഷർ ഗേജ്
ഉൽപ്പന്ന ഭാരം 100 ഗ്രാം
ഉൽപ്പന്ന അളവുകൾ 9.3 x 3.3 x 2 സെ.മീ
ബാറ്ററികൾ 2 Lithium-metal (included)
അളക്കൽ യൂണിറ്റുകൾ PSI, KPA, BAR, kg/cm²
കൃത്യത +/- 1%
മെറ്റീരിയൽ Metal core, ribbed plastic exterior
ത്രെഡ് തരം ഷ്രാഡർ

വാറൻ്റിയും പിന്തുണയും

This Michelin product is manufactured to high-quality standards. For warranty information or technical support, please refer to the documentation included with your purchase or visit the official Michelin automotive accessories webസൈറ്റ്. വാറന്റി ക്ലെയിമുകൾക്കായി നിങ്ങളുടെ വാങ്ങലിന്റെ തെളിവ് സൂക്ഷിക്കുക.

© 2023 Michelin. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.