TOOLTOP ET14S Thermal Imager Macro Lens User Manual

1. ഉൽപ്പന്നം കഴിഞ്ഞുview

The TOOLTOP ET14S Macro Lens is a dedicated accessory designed to enhance the close-up imaging capabilities of the TOOLTOP ET14S Thermal Imager. It allows for detailed thermal inspection of small components and circuits by reducing the minimum focus distance.

Important Note: This macro lens is specifically designed for the ET14S thermal imaging multimeter and is not compatible with ET15S, ET13S, or other models.

2. സജ്ജീകരണവും ഇൻസ്റ്റാളേഷനും

Follow these steps to correctly install the macro lens onto your TOOLTOP ET14S Thermal Imager:

1. Gently tilt the macro lens for proper alignment during installation.
2. Insert the front two corners of the macro lens into the designated card slot on the thermal imager.
3. Press the back of the macro lens firmly until the entire lens assembly is securely seated within the card slot.

3. പ്രവർത്തന നിർദ്ദേശങ്ങൾ

Once installed, the macro lens allows for close-up thermal imaging. Observe the following guidelines for optimal performance:

• The optimal working distance for the macro lens is approximately 2.5 cm from the target object.
• If the distance to the object exceeds 2.5 cm, the image may become blurred. In such cases, remove the macro lens and use the thermal imager in its normal operating mode.
• When using the macro lens, it may be necessary to slightly move the macro lens left and right to achieve the clearest focus on the target area.

4. പരിപാലനം

To ensure the longevity and performance of your macro lens:

• Keep the lens clean and free from dust and smudges. Use a soft, lint-free cloth specifically designed for optical lenses.
• Avoid touching the lens surface with bare hands.
• Store the macro lens in a protective case when not in use to prevent scratches and damage.
• Do not expose the lens to extreme temperatures or harsh chemicals.

5. പ്രശ്‌നപരിഹാരം

If you encounter issues with your macro lens, consider the following:

• മങ്ങിയ ചിത്രം: Ensure the working distance is approximately 2.5 cm. If the object is too far or too close, the image will be out of focus. Try slightly adjusting the lens position (left/right) as mentioned in the operating instructions.
• ലെൻസ് സുരക്ഷിതമായി ഘടിപ്പിക്കാത്തത്: Verify that the front two corners are correctly inserted into the card slot before pressing the back of the lens. Ensure no debris is obstructing the slot.
• അനുയോജ്യത പ്രശ്നങ്ങൾ: Confirm that your thermal imager is indeed the TOOLTOP ET14S model. This macro lens is not compatible with other models.

പ്രശ്നങ്ങൾ നിലനിൽക്കുകയാണെങ്കിൽ, കൂടുതൽ സഹായത്തിനായി ഉപഭോക്തൃ പിന്തുണയുമായി ബന്ധപ്പെടുക.

6 സ്പെസിഫിക്കേഷനുകൾ

7. വാറൻ്റിയും പിന്തുണയും

For warranty information, technical support, or any product-related inquiries, please contact the manufacturer or your point of purchase. Keep your purchase receipt as proof of purchase.