ആമുഖം
Thank you for choosing the Miele Complete C3 Calima Canister HEPA Vacuum Cleaner. This manual provides essential information for the safe and efficient operation, maintenance, and care of your appliance. Please read these instructions thoroughly before initial use to ensure optimal performance and to prevent damage.
1. സജ്ജീകരണവും അസംബ്ലിയും
1.1 അൺപാക്കിംഗ്
- പാക്കേജിംഗിൽ നിന്ന് എല്ലാ ഘടകങ്ങളും ശ്രദ്ധാപൂർവ്വം നീക്കം ചെയ്യുക.
- ഭാവിയിലെ ഗതാഗതത്തിനോ സംഭരണത്തിനോ വേണ്ടി പാക്കേജിംഗ് സൂക്ഷിക്കുക.
- Verify that all listed components are present.
1.2 വാക്വം ക്ലീനർ കൂട്ടിച്ചേർക്കൽ
- ഹോസ് അറ്റാച്ചുചെയ്യുക: Insert the hose connector into the suction opening on the vacuum cleaner until it clicks into place. To detach, press the release buttons on the side of the connector.
- Assemble the Telescopic Wand: Connect the handle to the telescopic wand until it clicks. Then, connect the telescopic wand to the floorhead (Turbobrush or Parquet Floor Brush) until it clicks. Adjust the wand length by pressing the release button and extending or retracting.
- Install FilterBag and Filters: Ensure a Miele GN AirClean FilterBag and AH50 HEPA Filter are correctly installed before use. Open the dust compartment lid, insert the FilterBag into the holder, and ensure the HEPA filter is securely seated in its compartment.
Figure 1: Miele Complete C3 Calima Canister HEPA Vacuum Cleaner with included accessories, including the STB 305-3 Turbobrush, SBB300-3 Parquet Floor Brush, and a pack of GN AirClean FilterBags and AH50 HEPA Filter.
1.3 പവർ കണക്ഷൻ
Extend the power cord from the rear of the appliance. Insert the plug into a suitable electrical outlet. The vacuum cleaner is designed for 120V AC power. Do not use extension cords unless absolutely necessary and ensure they are rated for the appliance's wattagഇ (1200 വാട്ട്സ്).
Figure 2: The power cord extending from the rear of the Miele Complete C3 Calima vacuum cleaner, ready for connection to an electrical outlet.
2. പ്രവർത്തന നിർദ്ദേശങ്ങൾ
2.1 Powering On/Off and Suction Control
Press the foot pedal power button (marked with a circle) on the canister to turn the vacuum cleaner on or off. The Miele Complete C3 Calima features a 1200-watt Vortex motor with adjustable suction power. Use the foot pedal controls marked with '+' and '-' to increase or decrease suction power according to the cleaning task and surface type.
ചിത്രം 3: ക്ലോസപ്പ് view of the control panel on the Miele Complete C3 Calima, showing the power button and suction adjustment controls.
2.2 Using Floorheads
- STB 305-3 Turbobrush: This air-driven turbobrush is ideal for low to medium pile carpets and area rugs. The rotating roller brush effectively loosens dirt, sweeps up fluff, and collects hair. Adjust suction power as needed to prevent the brush from sticking to the carpet.
- SBB300-3 Parquet Floor Brush: Designed for gentle yet effective cleaning of all smooth flooring, such as wood, tile, and laminate. Its maneuverable design allows it to reach under furniture and along baseboards.
Figure 4: The Miele STB 305-3 Turbobrush actively cleaning a carpeted surface.
Figure 5: The Miele Complete C3 Calima vacuum cleaner in operation, cleaning a light-colored rug.
2.3 Using Integrated Accessories
The vacuum cleaner includes three integrated accessories: a crevice tool, a dusting brush, and an upholstery tool. These are stored conveniently on the appliance. To use, detach the floorhead and telescopic wand, then connect the desired accessory directly to the handle.
- വിള്ളൽ ഉപകരണം: For cleaning narrow gaps, corners, and edges.
- ഡസ്റ്റിംഗ് ബ്രഷ്: For dusting delicate surfaces, curtains, and ornate items.
- അപ്ഹോൾസ്റ്ററി ഉപകരണം: For cleaning upholstered furniture, mattresses, and cushions.
2.4 Cord Rewind
To retract the power cord, gently pull the cord slightly and release. The automatic rewind mechanism will pull the cord back into the appliance. Guide the cord to prevent it from whipping.
3. പരിപാലനം
Regular maintenance ensures the longevity and optimal performance of your Miele vacuum cleaner.
3.1 Replacing the FilterBag
Replace the Miele GN AirClean FilterBag when the 'Change FilterBag' indicator on the canister turns red, or when suction power noticeably decreases. Always use genuine Miele GN AirClean FilterBags for best performance and filtration.
- പൊടി കമ്പാർട്ട്മെൻ്റ് ലിഡ് തുറക്കുക.
- Pull the tab on the FilterBag collar to seal the opening.
- Remove the full FilterBag and dispose of it.
- Insert a new Miele GN AirClean FilterBag into the holder, ensuring it is fully unfolded inside the compartment.
- Close the dust compartment lid securely.
3.2 HEPA ഫിൽട്ടർ മാറ്റിസ്ഥാപിക്കുന്നു
The AH50 HEPA AirClean Filter should be replaced approximately once a year, or when the filter change indicator (if present) signals replacement. This filter is crucial for maintaining the AirClean Sealed System and trapping fine dust and allergens.
- Locate the HEPA filter compartment, typically at the rear of the vacuum cleaner.
- Open the compartment and remove the old HEPA filter.
- Insert a new Miele AH50 HEPA AirClean Filter, ensuring it is correctly oriented and sealed.
- Close the filter compartment lid securely.
3.3 Replacing Pre-Motor Protection Filters
The pre-motor protection filter protects the motor from dust and debris. These filters are typically replaced with every fourth FilterBag change or as needed. Refer to your specific model's instructions for location and replacement.
3.4 Cleaning Floorheads and Accessories
Regularly inspect and clean the floorheads and accessories. Remove any tangled hair or threads from the Turbobrush roller. Wipe down all components with a dry or slightly damp തുണി. ഒരു ഭാഗവും വെള്ളത്തിൽ മുക്കരുത്.
4. പ്രശ്നപരിഹാരം
If you encounter issues with your Miele vacuum cleaner, consult the following common problems and solutions:
| പ്രശ്നം | സാധ്യമായ കാരണം | പരിഹാരം |
|---|---|---|
| വാക്വം ക്ലീനർ ആരംഭിക്കുന്നില്ല. | No power supply; power cord not fully inserted. | Check power plug and electrical outlet. |
| വലിച്ചെടുക്കൽ ശക്തി നഷ്ടപ്പെടുന്നു. | FilterBag full; hose/wand/floorhead blocked; filters clogged. | Replace FilterBag; check for blockages and remove; replace HEPA and pre-motor filters. |
| പ്രവർത്തന സമയത്ത് അസാധാരണമായ ശബ്ദം. | Foreign object in hose/floorhead; motor issue. | Check for and remove foreign objects. If noise persists, contact Miele Service. |
| Turbobrush not rotating. | Blockage in brush roller; insufficient suction. | Clean brush roller; increase suction power. |
If the problem persists after attempting these solutions, please contact Miele Customer Service or an authorized Miele service center.
5 സ്പെസിഫിക്കേഷനുകൾ
- ബ്രാൻഡ്: മൈലെ
- മോഡൽ: Complete C3 Calima (10796510_K1)
- തരം: കാനിസ്റ്റർ വാക്വം ക്ലീനർ
- പ്രത്യേക സവിശേഷത: HEPA ഫിൽട്ടറേഷൻ
- ഫിൽട്ടർ തരം: HEPA Filter (AH50), AirClean FilterBags (GN), Pre-Motor Protection Filters
- വാട്ട്tage: 1200 വാട്ട്സ്
- ശേഷി: 4.8 Liters (FilterBag)
- ശബ്ദ നില: 60 ഡി.ബി
- ഉൽപ്പന്ന അളവുകൾ: 9.1"L x 9.1"W x 9.1"H
- ഇനത്തിൻ്റെ ഭാരം: 20 പൗണ്ട്
- ഉൾപ്പെടുത്തിയ ഘടകങ്ങൾ: Miele Complete C3 Calima Canister Unit, STB 305-3 Turbobrush, SBB300-3 Parquet Floor Brush, Telescopic Wand, Crush-Proof Ergonomic Hose, Crevice Tool, Dusting Brush, Upholstery Tool, GN AirClean FilterBags, AH50 HEPA Filter, Pre-Motor Protection Filters.
6. വാറൻ്റി വിവരങ്ങൾ
Miele products are manufactured to the highest quality standards and are subject to comprehensive checks. For detailed information regarding the warranty period, terms, and conditions applicable to your Miele Complete C3 Calima vacuum cleaner, please refer to the warranty card included with your purchase or visit the official Miele webസൈറ്റ്. വാറന്റി ക്ലെയിമുകൾക്കായി നിങ്ങളുടെ വാങ്ങലിന്റെ തെളിവ് സൂക്ഷിക്കുക.
7. പിന്തുണയും സമ്പർക്കവും
For further assistance, technical support, or to purchase genuine Miele accessories and spare parts, please visit the official Miele website or contact Miele Customer Service. Contact details can typically be found on the Miele webസൈറ്റിലോ നിങ്ങളുടെ ഉപകരണത്തിനൊപ്പം നൽകിയിരിക്കുന്ന ഡോക്യുമെന്റേഷനിലോ.
Miele Official Webസൈറ്റ്: www.miele.com
