1. ആമുഖം
This manual provides essential information for the safe and effective installation, operation, and maintenance of your Okin Model 1.28.000.110.30 Deltadrive Series Motor. This motor is designed as a replacement actuator for electric recliner lift chairs.
പ്രധാന അനുയോജ്യതാ കുറിപ്പ്: It is crucial to verify that the motor SKU "1.28.000.110.30" on the product label and the shapes of the cable connectors/motor end are identical to your existing unit. This motor is not universally compatible and cannot replace other models.
2. ഉൽപ്പന്നം കഴിഞ്ഞുview
The Okin Deltadrive Series Motor 1.28.000.110.30 is a low-voltage DC motor (24V) designed for quiet and safe operation in electric recliners. It features specific stroke and installation dimensions critical for proper function.
Figure 2.1: Okin Deltadrive Series Motor 1.28.000.110.30, showing the main unit and included pins.
2.1 Identifying Your Motor
Before installation, confirm the model number on the motor's label. The correct model number is 1.28.000.110.30.
ചിത്രം 2.2: ക്ലോസപ്പ് view of the motor label, highlighting the model number 1.28.000.110.30 and serial number Q19060860 00029.
3 സാങ്കേതിക സവിശേഷതകൾ
| ആട്രിബ്യൂട്ട് | മൂല്യം |
|---|---|
| മോഡൽ നമ്പർ | 1.28.000.110.30 |
| മോട്ടോർ തരം | കുറഞ്ഞ വോള്യംtage DC motor (24V) |
| നിലവിലുള്ളത് | 2.2എ |
| ഓപ്പറേഷൻ ഫ്രീക്വൻസി | On 1 min / Off 8 min |
| സ്ട്രോക്ക് | 250 എംഎം (9.84 ഇഞ്ച്) |
| ഏറ്റവും കുറഞ്ഞ ഇൻസ്റ്റലേഷൻ അളവുകൾ | 435 എംഎം (17.13 ഇഞ്ച്) |
| Maximum Installation Dimensions | 685 എംഎം (26.97 ഇഞ്ച്) |
| രൂപഭാവം | Black (PA), Silver White (Aluminum) |
| മെറ്റീരിയൽ | അലുമിനിയം |
| ഭാരം | 5.59 പൗണ്ട് |
| കണക്ഷനുകൾ | 2 Pin Flat Round Power Transformer Connection, 5 Pin Hand Control Plug Connection |
Figure 3.1: Motor dimensions, illustrating the stroke and minimum installation size.
4. ഇൻസ്റ്റലേഷൻ നിർദ്ദേശങ്ങൾ
Replacing your existing actuator requires careful attention to detail. Ensure the chair is unplugged from the power source before beginning installation.
- തയ്യാറാക്കൽ: Unplug the recliner from the wall outlet. Carefully flip the chair over or position it to access the existing motor and its connections.
- പഴയ മോട്ടോർ വിച്ഛേദിക്കുക: Disconnect the 2-pin flat round power transformer connection and the 5-pin hand control plug connection from the old motor. Note their orientation.
- പഴയ മോട്ടോർ നീക്കം ചെയ്യുക: The old actuator is typically held in place by pins and locking springs at each end. Carefully remove these pins to detach the old motor.
- പുതിയ മോട്ടോർ സ്ഥാപിക്കുക: Position the new Okin Deltadrive motor in the same location as the old one. Secure it using the pins and locking springs. Ensure the motor is properly aligned.
- കേബിളുകൾ ബന്ധിപ്പിക്കുക: Connect the 2-pin flat round power transformer cable and the 5-pin hand control plug to the corresponding ports on the new motor. Ensure connections are secure.
- കേബിൾ മാനേജുമെന്റ്: Use zip-ties or other appropriate fasteners to secure loose cables, preventing them from interfering with moving parts or becoming damaged.
- പവർ കോർഡ് നീളം: Be aware that the power cord may be short (approximately 1-2 inches long). An extension may be required depending on your setup.
Figure 4.1: Motor connections, illustrating the 2-pin power and 5-pin hand control plugs.
Figure 4.2: Detail of the motor's end connection point, where it attaches to the recliner mechanism.
5. ഓപ്പറേഷൻ
Once installed, plug the recliner back into a power outlet. Use your recliner's hand control to operate the motor. The motor is designed for quiet and smooth operation.
- ചാരിയിരിക്കുന്ന അവസ്ഥ: Press and hold the appropriate button on your hand control to extend the footrest and recline the chair.
- നേരെ മടങ്ങുന്നു: Press and hold the appropriate button to retract the footrest and return the chair to the upright position.
- ഡ്യൂട്ടി സൈക്കിൾ: The motor has an operation frequency of "On 1 min / Off 8 min". This means it can operate continuously for up to 1 minute, followed by a mandatory 8-minute rest period to prevent overheating and ensure longevity. Adhering to this duty cycle is essential.
6. പരിപാലനം
Regular maintenance helps ensure the longevity and optimal performance of your Okin Deltadrive motor.
- വൃത്തിയാക്കൽ: Keep the motor and surrounding areas free from dust and debris. Use a dry cloth for cleaning. Do not use liquid cleaners directly on the motor.
- കണക്ഷൻ പരിശോധന: Periodically inspect all cable connections (power and hand control) to ensure they are secure and free from damage.
- ചലിക്കുന്ന ഭാഗങ്ങൾ: Ensure that no foreign objects obstruct the movement of the motor or the recliner mechanism.
- ലൂബ്രിക്കേഷൻ: The motor is generally maintenance-free regarding internal lubrication. Do not attempt to lubricate internal components unless specifically instructed by Okin support.
7. പ്രശ്നപരിഹാരം
If you encounter issues with your Okin Deltadrive motor, refer to the following common problems and solutions:
| പ്രശ്നം | സാധ്യമായ കാരണം | പരിഹാരം |
|---|---|---|
| Motor does not operate / No movement. |
|
|
| Motor jerks or does not move smoothly. |
|
|
| Chair does not hold position (e.g., reclines back when trying to stay upright). |
|
|
| Power cord is too short. |
|
|
8. വാറൻ്റിയും പിന്തുണയും
For warranty information or technical support, please contact Okin customer service. Keep your purchase receipt and the motor's serial number (found on the label) readily available when contacting support.
Visit the official Okin Store for more information: Okin Store on Amazon
