1. ആമുഖം
This manual provides essential information for the safe and effective operation of your VOLANTEXRC P-47 Thunderbolt RC Plane (Model 761-16 RTF). This 4-channel WWII warbird model is designed for beginners and experienced pilots alike, featuring the Xpilot gyro stabilization system and one-key aerobatic functions. Please read this manual thoroughly before operating the aircraft.
2. പാക്കേജ് ഉള്ളടക്കം
താഴെ കൊടുത്തിരിക്കുന്ന എല്ലാ ഇനങ്ങളും നിങ്ങളുടെ പാക്കേജിൽ ഉണ്ടെന്ന് ഉറപ്പാക്കുക:
- P-47 Thunderbolt RC Plane (Fully Assembled)
- 2.4Ghz ട്രാൻസ്മിറ്റർ (റിമോട്ട് കൺട്രോൾ)
- ലിഥിയം പോളിമർ ബാറ്ററികൾ (2 എണ്ണം ഉൾപ്പെടുന്നു)
- യുഎസ്ബി ചാർജിംഗ് കേബിൾ
- സ്പെയർ പ്രൊപ്പല്ലറുകൾ
- ലാൻഡിംഗ് ഗിയർ സെറ്റ്
- ഉപയോക്തൃ മാനുവൽ (ഈ പ്രമാണം)
Image: The VOLANTEXRC P-47 Thunderbolt RC Plane shown with its remote control, two batteries, spare propellers, USB charging cable, and landing gear.
3. Setup and Pre-Flight Preparation
3.1. ബാറ്ററി ചാർജിംഗ്
- Connect the provided Lithium Polymer battery to the USB charging cable.
- Plug the USB charging cable into a suitable USB power source (e.g., computer USB port, USB wall adapter).
- The indicator light on the USB charger will show the charging status. Refer to the charger's specific instructions for light indications (typically red for charging, green for fully charged).
- Ensure batteries are fully charged before each flight for optimal performance and flight time.
3.2. ട്രാൻസ്മിറ്റർ ബാറ്ററി ഇൻസ്റ്റാളേഷൻ
The transmitter requires 4 AA batteries (not included). Open the battery compartment on the back of the transmitter and insert the batteries, observing correct polarity.
3.3. Landing Gear Installation (Optional)
The aircraft comes with a landing gear set. For ground take-offs and landings, attach the landing gear as shown in the diagram. For hand-launching, especially for beginners or in grassy areas, the landing gear can be omitted to prevent damage during rough landings.
3.4. Propeller Check
The plane is pre-assembled. Ensure the propeller is securely attached. The propeller features a saver mechanism, allowing it to detach upon impact to prevent damage. Reattach if it comes off.
ചിത്രം: ക്ലോസ്-അപ്പ് view of the propeller and its saver mechanism, designed to protect the propeller and motor during impacts.
4. പ്രവർത്തന നിർദ്ദേശങ്ങൾ
4.1. Power On Sequence
- ആദ്യം ട്രാൻസ്മിറ്റർ ഓണാക്കുക.
- Connect the flight battery to the aircraft. Place the aircraft on a level surface.
- Wait for the aircraft to bind with the transmitter. A series of beeps or flashing lights will indicate successful binding.
4.2. Flight Control Modes (Xpilot Stabilization System)
The Xpilot gyro stabilization system offers three flight control levels:
- തുടക്കക്കാരൻ മോഡ് (പൂർണ്ണ സഹായം): Provides maximum stabilization and restricted control angles, making it easier for new pilots to learn.
- ഇന്റർമീഡിയറ്റ് മോഡ് (ഭാഗിക സഹായി): Offers increased control angles with some stabilization, suitable for pilots gaining confidence.
- വിദഗ്ദ്ധ മോഡ് (മാനുവൽ നിയന്ത്രണം): Disables stabilization for full manual control, ideal for experienced pilots performing advanced maneuvers.
Switch between modes using the designated button on the transmitter. Refer to the transmitter diagram for button location.
Image: Visual representation of the three flight modes: Full Assist (restricted angle), Soft Assist (increased angle), and No Assist (manual control).
4.3. ടേക്ക്-ഓഫ്
For beginners, hand-launching is recommended:
- Hold the middle of the plane firmly.
- Ensure you are in Beginner or Intermediate flight mode.
- Advance the throttle to approximately 2/3 power.
- Gently throw the plane forward horizontally into the wind.
For ground take-offs with landing gear, gradually increase throttle and steer using the rudder (if applicable) until the plane gains sufficient speed for lift-off.
Image: Step-by-step guide on how to hand-launch the RC plane, showing proper grip and launch direction.
4.4. അടിസ്ഥാന ഫ്ലൈറ്റ് നിയന്ത്രണങ്ങൾ
Your 4-channel transmitter controls the following:
- ത്രോട്ടിൽ: Controls motor speed and altitude (left stick, vertical).
- എയിലറോണുകൾ: Controls roll (right stick, horizontal).
- എലിവേറ്റർ: Controls pitch (right stick, vertical).
- റഡ്ഡർ: Controls yaw (left stick, horizontal).
4.5. വൺ-കീ എയറോബാറ്റിക്സ്
To perform aerobatic maneuvers, press the dedicated one-key aerobatics button on the transmitter and then pull the right joystick in the desired direction (e.g., up for a loop, left/right for a roll). The Xpilot system will automatically execute the maneuver.
Image: Illustration of the one-key aerobatics feature, showing the button on the transmitter and the resulting flight path.
4.6. Low Battery / Out of Control Alarm
The transmitter will emit an audible alarm when the aircraft's battery is low or if the aircraft flies beyond the 656 ft (200m) control range. Upon hearing this alarm, immediately guide the aircraft back and prepare for landing.
Image: Depiction of the low battery and out-of-range alarm, showing the plane flying at a distance and the transmitter indicating a low battery warning.
5. പരിപാലനം
5.1. ജനറൽ കെയർ
- Keep the aircraft clean and free from dirt, dust, and moisture.
- Inspect the airframe for any damage after each flight. The durable foam construction is designed to withstand minor impacts.
- Ensure all control surfaces (ailerons, elevator, rudder) move freely and are not obstructed.
5.2. പ്രൊപ്പല്ലർ പരിപാലനം
Regularly check the propeller for cracks or damage. Replace damaged propellers immediately using the provided spares. Note that the 2-blade propeller is generally more durable than the 3-blade propeller during impacts.
5.3. ബാറ്ററി സംഭരണം
Store Lithium Polymer batteries in a cool, dry place, away from direct sunlight and flammable materials. Do not store fully charged or fully discharged for extended periods. Refer to battery safety guidelines for proper storage voltage.
6. പ്രശ്നപരിഹാരം
| പ്രശ്നം | സാധ്യമായ കാരണം | പരിഹാരം |
|---|---|---|
| Aircraft does not respond to controls. | Unbound transmitter/receiver, low transmitter battery, aircraft battery disconnected. | Ensure proper power-on sequence. Check transmitter batteries. Reconnect aircraft battery. |
| Aircraft flies erratically or drifts. | Incorrect flight mode, trim settings, damaged control surface. | Switch to Beginner mode. Adjust trim on transmitter. Inspect control surfaces for damage. |
| Propeller not spinning or grinding noise. | Propeller detached, motor obstruction, damaged motor/gearbox. | Reattach propeller. Clear any obstructions. Contact support if motor/gearbox is damaged. |
| ചെറിയ ഫ്ലൈറ്റ് സമയം. | Battery not fully charged, old battery, aggressive flying. | Ensure battery is fully charged. Consider replacing old batteries. Fly less aggressively. |
| Aircraft loses signal at short range. | Interference, damaged antenna, low transmitter battery. | Fly in open areas away from interference. Check transmitter batteries. |
7 സ്പെസിഫിക്കേഷനുകൾ
| ഫീച്ചർ | വിശദാംശങ്ങൾ |
|---|---|
| മോഡൽ നമ്പർ | EXA76116RRB2 (761-16 RTF) |
| ഉൽപ്പന്ന അളവുകൾ | 20 x 13.38 x 4 ഇഞ്ച് |
| ഇനത്തിൻ്റെ ഭാരം | 1.76 ഔൺസ് |
| ചാനലുകൾ നിയന്ത്രിക്കുക | 4 Channels (Aileron, Elevator, Rudder, Throttle) |
| സ്റ്റെബിലൈസേഷൻ സിസ്റ്റം | എക്സ്പൈലറ്റ് ഗൈറോ സ്റ്റെബിലൈസർ |
| റിമോട്ട് കൺട്രോൾ ഫ്രീക്വൻസി | 2.4GHz |
| ദൂരം നിയന്ത്രിക്കുക | 656 അടി (200 മീ) വരെ |
| ഫ്ലൈറ്റ് സമയം | Up to 15 minutes (per battery) |
| ബാറ്ററികൾ ആവശ്യമാണ് | 2 Lithium Polymer (included for plane), 4 AA (not included for transmitter) |
| ശുപാർശ ചെയ്യുന്ന പ്രായം | 14 വർഷവും അതിൽ കൂടുതലും |
| നിർമ്മാതാവ് | എക്സ്ഹോബി |
Image: Diagram showing the length (15.75 inches) and wingspan (12.13 inches) of the P-47 Thunderbolt RC plane.
8. വാറൻ്റിയും പിന്തുണയും
For warranty information, technical support, or replacement parts, please contact the manufacturer, EXHOBBY, directly. Refer to the product packaging or the official VOLANTEXRC webനിലവിലെ കോൺടാക്റ്റ് വിശദാംശങ്ങൾക്കായി സൈറ്റ്.
Always ensure you are using genuine VOLANTEXRC parts for optimal performance and safety.
