Roborock Filter for F25 RT/F25 Combo Wet Vacuum Cleaner

1. ആമുഖം

This instruction manual provides essential information for the proper use and maintenance of your Roborock Filter, Model SCLWTZ09RR. This filter is specifically designed for use with Roborock F25 RT and F25 Combo wet vacuum cleaners. Adhering to these instructions will help ensure optimal performance and longevity of your vacuum cleaner's filtration system.

2. ഉൽപ്പന്നം കഴിഞ്ഞുview

The Roborock Filter (SCLWTZ09RR) is a crucial component for maintaining the cleaning efficiency of your F25 RT or F25 Combo wet vacuum cleaner. It captures dust, debris, and other particles, preventing them from re-entering the air and protecting the vacuum's motor. Regular inspection and maintenance of the filter are vital for consistent performance.

ചിത്രം 2.1: മുൻഭാഗം view of the Roborock SCLWTZ09RR filter, showing its pleated design for efficient particle capture.

ചിത്രം 2.2: കോണാകൃതിയിലുള്ള മുകൾഭാഗം view of the Roborock SCLWTZ09RR filter, highlighting its structural design.

Figure 2.3: The Roborock filter packaging, typically containing two replacement filters.

3. ഇൻസ്റ്റലേഷൻ നിർദ്ദേശങ്ങൾ

Follow these steps to properly install or replace the filter in your Roborock F25 RT or F25 Combo wet vacuum cleaner:

1. പവർ ഓഫ്: Ensure the vacuum cleaner is turned off and unplugged from the power source before beginning any maintenance.
2. ഫിൽട്ടർ കമ്പാർട്ട്മെന്റ് കണ്ടെത്തുക: Identify the filter compartment on your Roborock F25 RT or F25 Combo. Refer to your vacuum cleaner's main manual for the exact location if unsure.
3. പഴയ ഫിൽറ്റർ നീക്കം ചെയ്യുക: Open the filter compartment cover. Carefully grasp the old filter and pull it out. Dispose of the old filter responsibly.
4. പുതിയ ഫിൽറ്റർ ചേർക്കുക: Take a new Roborock SCLWTZ09RR filter. Align the new filter with the slot in the compartment and push it firmly until it clicks into place. Ensure it is seated correctly to prevent air leaks.
5. കമ്പാർട്ട്മെന്റ് അടയ്ക്കുക: ഫിൽട്ടർ കമ്പാർട്ട്മെന്റ് കവർ സുരക്ഷിതമായി അടയ്ക്കുക.

Figure 3.1: Illustration of a hand removing or inserting the filter into the designated compartment of the Roborock wet vacuum cleaner.

4. പ്രവർത്തന പരിഗണനകൾ

Once the filter is correctly installed, your Roborock F25 RT or F25 Combo wet vacuum cleaner is ready for operation. The filter works continuously during cleaning cycles to capture fine particles. To ensure optimal performance:

• Always ensure the filter is dry before re-installing it after cleaning.
• Never operate the vacuum cleaner without a filter installed, as this can damage the motor and void your warranty.
• If you notice a decrease in suction power or unusual noises, check the filter for blockages or damage.

5. പരിപാലനവും പരിചരണവും

Regular cleaning and timely replacement of the filter are essential for maintaining your vacuum cleaner's performance and extending its lifespan.

5.1. ഫിൽട്ടർ വൃത്തിയാക്കൽ

The Roborock SCLWTZ09RR filter is designed for hand washing:

1. ഫിൽറ്റർ നീക്കം ചെയ്യുക: Follow steps 1-3 from the Installation section to remove the filter from the vacuum cleaner.
2. കഴുകുക: Rinse the filter under cool, running water. Gently tap the filter to dislodge any trapped dirt and debris. Avoid using harsh detergents or brushes, as these can damage the filter material.
3. പൂർണ്ണമായും ഉണക്കുക: Allow the filter to air dry completely for at least 24 hours before re-installing it. Do not use a dryer or direct heat, as this can deform the filter. Ensure it is thoroughly dry to prevent mold or mildew growth.

5.2. ഫിൽട്ടർ മാറ്റിസ്ഥാപിക്കൽ

It is recommended to replace the filter every 3 to 6 months, or more frequently depending on usage and cleaning environment. Signs that a filter needs replacement include:

• Noticeable decrease in suction power, even after cleaning.
• Visible damage or tears to the filter material.
• Persistent odors emanating from the vacuum cleaner.

6. പ്രശ്‌നപരിഹാരം

If you encounter issues related to the filter, consider the following:

• കുറച്ച സക്ഷൻ: Check if the filter is clogged with debris. Clean or replace the filter as necessary. Ensure the filter is installed correctly and the compartment cover is sealed.
• അസാധാരണമായ മണം: This often indicates a dirty filter. Clean the filter thoroughly and ensure it is completely dry before re-installation. If odors persist, replace the filter.
• ഫിൽട്ടർ യോജിക്കുന്നില്ല: Ensure you are using the correct filter model (SCLWTZ09RR) for your Roborock F25 RT or F25 Combo. Verify that the filter is aligned properly before pushing it into place.

For issues not resolved by these steps, please refer to your vacuum cleaner's main instruction manual or contact Roborock customer support.

7 സ്പെസിഫിക്കേഷനുകൾ

8. വാറൻ്റി വിവരങ്ങൾ

This filter is a consumable accessory. Please refer to the warranty policy provided with your Roborock F25 RT or F25 Combo wet vacuum cleaner for details regarding accessories and replacement parts. Typically, consumable items like filters are not covered under the main product warranty for wear and tear, but may be covered against manufacturing defects for a limited period.

Always purchase genuine Roborock replacement parts to ensure compatibility and maintain your vacuum cleaner's warranty.

9. ഉപഭോക്തൃ പിന്തുണ

For further assistance, technical support, or to purchase additional genuine Roborock filters, please contact Roborock customer service or visit the official Roborock webസൈറ്റ്.

• ഓൺലൈൻ പിന്തുണ: Visit the official Roborock webപതിവുചോദ്യങ്ങൾ, ട്രബിൾഷൂട്ടിംഗ് ഗൈഡുകൾ, ബന്ധപ്പെടാനുള്ള വിവരങ്ങൾ എന്നിവയ്ക്കുള്ള സൈറ്റ്.
• ബന്ധപ്പെടാനുള്ള വിവരങ്ങൾ: Refer to the contact details provided in your main vacuum cleaner manual or on the Roborock webപ്രാദേശിക പിന്തുണയ്ക്കുള്ള സൈറ്റ്.